Table of Contents
Advertisement
Installation & Connections
Unpacking Instructions
The SC-IP card and components are shipped in shock-absorbent packing within a corrugated box.
Table 2-1
lists the standard SC-IP equipment. Some components will not be required/supplied for
your network installation. Remove each component from the box and perform a thorough
inspection. If any component appears damaged, contact the shipper immediately. All damaged
components must be retained until an inspection by the shipper has been completed. If necessary to
re-package and return the unit, use the original box and packing material.
Note
For cable part numbers, the -XXX designation refers to cable length, in feet.
SC-IP Equipment
Table 2-1
SC-IP Equipment
SpectraComm IP Router Card
(rack-mounts in SC2000 or SC5000 shelf)
SpectraComm IP Router Card (for RA-1000 Enclosure)
Factory-installed Default Configuration Profile (01-99)
Cable, 8-pin modular to 8-pin modular straight-thru
Cable, 8-pin modular to 8-pin modular, crossover
Cable, CAT5 UTP straight-thru
Cable, CAT5 UTP crossover
Cable, Interface, RJ-45 to RJ-45
Cable, switched network
Adapter, RS232-RS561 DB25M to RJ45
Adapter, IBMPC-RS561 DB9 M to RJ45
Adapter Cable, Interface
Splitter Adapter, interface, RJ-45 plug to two RJ-45 plugs
Cable, Interface, switched network, RJ-11 to RJ-45
Cable, DTE Interface, shielded DB25M to 50-pin amphenol
Cable, DCE Interface, shielded DB25M to 50-pin amphenol
Harmonica Block, Interface, Telco, 50-pin to 8-pos RJ-45
Shelf System Options
Table 2-2
lists the shelf systems and additional products that can be used with the SC-IP. Unless
otherwise stated in the table, each shelf system includes the following components:
•
base shelf and two mounting brackets (19/23-inch standard) with mounting hardware
•
one power supply and one power supply blank front panel
•
one Zone 1 connector panels
•
one 16-slot DB25 Zone 3 connector panel.
Note
As needed, refer to the SC/UAS Shelf Manual (P/N 010R302-000), the SpectraComm 2000 Shelf Manual, (P/
N 010R358-000), and the SC 1001/1002 Enclosure Manual (P/N 010R112-000).
2-2
Description
SpectraComm IP Router Card
Installation and Operation Manual
Connectivity
LAN, T1/FT1
(PPP , Ethernet)
Router or LAN-X modes
T1 (Network Port)
T1 (Network Port)
LAN
S-078H010-XXX
(Ethernet Ports 1 & 2)
S-078H011-XXX
Craft Port
T1/Modem Port
Craft Port
Craft Port
AUX Port (S1)
(T1/Modem Line Port)
From Internal Modem
(T1/Modem Line Port)
From Term Serv Port
From Term Serv Port
To Terminal Device
076R200-000
Issue 2
Overview
Part Number
076P032-001
076A032-015
076U032-D##
022H024-XXX
027H266-XXX
830-128-8XX
-Future Use-
029H210-001
029H211-001
-Future Use-
-Future Use-
-Future Use-
025H502-004
025H503-004
209-036-034
Advertisement
Table of Contents
