Ups (Uninterruptible Power Supply); One Psu Is Installed - Buffalo TeraStation 5010 TS5210DN User Manual

• The TeraStation does not support using Wake-on-LAN and port trunking at the same time. You may use either
feature, but not both at the same time.
• If the TeraStation is connected to a Buffalo wireless router configured for remote access, then it may be turned on
from outside the local network (from the WAN side). To use this feature, connect the router to LAN port 1 or 2 on
the TeraStation.

UPS (Uninterruptible Power Supply)

If a UPS (sold separately) is attached, the TeraStation can be automatically shut down to protect data in the event of
a power outage.
The procedure to configure for a UPS device is different depending on how many power supply units are installed
on your TeraStation. Depending on your setup, follow one of the procedures below for your TeraStation.

One PSU Is Installed

1
Plug the power cable of the UPS to a wall socket.
2
Connect the power cable of the TeraStation to the UPS.
3
Connect the UPS and TeraStation.
4
Turn on the UPS, then the TeraStation.
5
In Settings, click Management.
6
Click to the right of "Power Management".
7
Click Edit.
136