Buffalo TeraStation 5010 TS5210DN User Manual page 90

Code Description
The drive capacity of the
Code 11 backup destination TeraStation
became full.
Could not communicate
between backup source and
destination TeraStations.
Code 12
The settings of the TeraStation
were changed while the
backup job was running.
Insufficient memory on the
Code 14 TeraStation was not enough
Code 22 so that the backup job did not
run.
The connection was
Code 20 disconnected while the
backup job was running.
Invalid characters were used in
the filename or folder name of
the backup destinations.
Code 23
The backup destination files
were updated while the
backup job was running.
Corrective Action
Delete unnecessary files and folders.
Verify that the Ethernet cable is
securely connected and that the hub
or other devices on the network are
turned on.
Do not change the settings while the
backup job is running. If changed, the
connection is temporarily terminated
and the backup job will fail.
Reduce the number of backup
destination files or disable any other
functions running at the same time.
Do not change the settings while the
backup job is running. If changed, the
connection is temporarily terminated
and the backup job will fail.
Change the filename or folder
name using compatible characters.
Available characters are described in
the "Adding a Shared Folder" section
in chapter 3.
Do not overwrite the backup
destination files while the backup job
is running. If updated, the backup
destination files will not be backed up
and the backup job will fail.
89
Log Example
rsync error: error
in file IO (code 11)
at receiver.c(389)
[receiver=3.1.0]
rsync error: error in
rsync protocol data
stream (code 12) at
io.c(515)
ERROR: out of
memory in flist_
expand
rsync error: error
allocating core
memory buffers
(code 22) at util.c(120)
[sender=2.6.8]
rsync: fork failed in
do_recv: Cannot
allocate memory (12)
rsync error: error
in IPC code (code
14) at main.c(655)
[receiver=2.6.8]
rsync error: received
SIGINT, SIGTERM, or
SIGHUP (code 20) at
rsync.c(242)
rsync error: some
files could not be
transferred (code 23)
at main.c(702)