Buffalo TeraStation 5010 TS5210DN User Manual page 16

6
LAN LED ( )
When any LAN ports are connected, this LED glows blue. It blinks when the connection is active.
7
Info LED ( )
If there is a status message, the amber info LED will light up. Check the Settings interface or NAS Navigator2 to
see the status message.
8
Drive Status LED (
This LED blinks blue when drives are accessed.
9
Drive Error LED (
Normally, this LED is extinguished. If a drive fails, its LED will turn red.
10
USB 2.0 Port (
Compatible Buffalo USB drives, USB flash drives, digital cameras, and USB UPS connections can be connected.
USB hubs are not supported.
11
Power Connector
Use the included power cable to connect to an UPS, surge protector, or outlet.
12
Fan
Spins to avoid overheating inside. Do not block the fan.
13
Micro-USB Port
Factory use only.
14
USB 3.0 Port (
Compatible Buffalo USB drives, USB flash drives, digital cameras, and USB UPS connections can be connected.
USB hubs are not supported.
15
LAN Port 1 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
16
LAN Port 2 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
17
LAN Port 3 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 10 Gbps, all network devices must be compatible with 10GbE.
18
LAN Port 4 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 10 Gbps, all network devices must be compatible with 10GbE.
19
Link/Act LED
Glows and blinks green when the unit is connected to a network.
)
)
)
)
15