Buffalo TeraStation 5010 TS5210DN User Manual page 14

10
Init Button
Hold down this button with something pointed to initialize the TeraStation's admin username and password,
IP settings, SSL, and service port restriction settings to their factory default values. The effects of this button
can be modified in Settings.
11
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
12
Fan
Spins to avoid overheating inside. Do not block the fan.
13
USB 3.0 Port (
Compatible Buffalo USB drives, USB flash drives, digital cameras, and USB UPS connections can be connected.
USB hubs are not supported.
14
LAN Port 1 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
15
LAN Port 2 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
16
LAN Port 3 ( )
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 10 Gbps, all network devices must be compatible with 10GbE.
17
Power Connector
Use the included power cable to connect to an UPS, surge protector, or outlet.
18
Anti-Theft Security Slot (
Use this slot to secure your TeraStation with a cable lock (not included).
19
Serial Number
This sticker shows the TeraStation's serial number.
20
UID Button
Press the UID button on the front or the back of the unit to cycle the blue LED on and off.
21
Link LED
Glows green when the unit is connected to a network.
22
Link LED on 100 Mbps, 2.5 Gbps, and 5 Gbps
Glows amber when the unit is connected to a network at 100 Mbps or 2.5 and 5 Gbps.
23
Link LED on 1000 Mbps
Glows green when the unit is connected to a network at 1000 Mbps.
24
Link LED on 10 Gbps
Glows blue when the unit is connected to a network at 10 Gbps.
)
)
13