Ups (Uninterruptible Power Supply) - Buffalo TeraStation 3010 User Manual

Chapter 7 Advanced Features
4
Enable "Wake-on-LAN", then click OK.
Wake-on-LAN is now enabled. As long as the TeraStation is connected to a power source and the network, you can
turn it on remotely.
Notes:
• After receiving the Wake-on-LAN packet, the TeraStation may take approximately five minutes to be ready to use.
• If a power outage occurs while Wake-on-LAN is enabled, the TeraStation will automatically start up after power is
restored.
• To use Wake-on-LAN, you'll need Wake-on-LAN software that sends magic packets. The TeraStation does not
include Wake-on-LAN software.
• The TeraStation does not support using Wake-on-LAN and port trunking at the same time. You may use either
feature, but not both at the same time.
• If the TeraStation is connected to a Buffalo wireless router configured for remote access, then it may be turned on
from outside the local network (from the WAN side). To use this feature, connect the router to LAN port 1 or 2 on
the TeraStation.

UPS (Uninterruptible Power Supply)

If a UPS (sold separately) is attached, the TeraStation can be automatically shut down to protect data in the event of
a power outage.
1
Plug the power cable of the UPS to a wall socket.
2
Connect the power cable of the TeraStation to the UPS.
3
Connect the UPS and TeraStation.
4
Turn on the UPS, then the TeraStation.
5
From Settings, click Management.
155