VERITAS NetBackup 5240 Hardware Installation Manual page 59

Configuring the IPMI from the NetBackup Appliance Shell Menu
8
Use a Cat5 or a Cat6 cable to connect the remote management port to the
network.
Note: The eth4 (NIC5) and eth5 (NIC6) ports on a 5240 appliance require Cat
6 cables.
9
Make sure you can reach the Veritas Remote Management Console over the
network by using the new address in a web browser.
10
The appliance is ready for initial configuration. See the NetBackup Appliance
Initial Configuration Guide for the appropriate platform for information about
initial configuration requirements and procedures.
Note: Once the initial configuration has been completed, you can connect NIC1
(eth0) to an administrative network that does not provide any backup data
transfer.
Installation procedures 59