VERITAS NetBackup 5230 Configuration Manual page 68

Performing the initial configuration on a 52xx media server appliance from the NetBackup Appliance Shell
13
Set the role for the appliance to a media server.
Note: Before you configure this appliance as a media server, you must add
the name of this appliance to the master server that must work with this
appliance.
From the Main_Menu > Appliance view, run the following command:
Media MasterServer
Where MasterServer is either a standalone master server, a multihomed master
server, or a clustered master server. The following defines each of these
scenarios:
Standalone master server
Multihomed master server
Clustered master server
This scenario shows one master server host name. This
name does not need to be a fully qualified name as long
as your appliance recognizes the master server on your
network. The following is an example of how the
command would appear.
Media MasterServerName
In this scenario, the master server has more than one
host name that is associated with it. You must use a
comma as a delimiter between the host names. The
following is an example of how the command would
appear.
Media MasterNet1Name,MasterNet2Name
In this scenario, the master server is in a cluster. Veritas
recommends that you list the cluster name first, followed
by the active node, and then the passive nodes in the
cluster. This list requires you to separate the node
names with a comma. The following is an example of
how the command would appear.
Media
MasterClusterName,ActiveNodeName,PassiveNodeName
Initial configuration procedures 68
Menu