VERITAS NetBackup 5230 Configuration Manual page 32

Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console
Add the name of this media server to the master server that you plan to use
■
with it.
If a firewall exists between the master server and this media server, open the
■
appropriate ports as described in the link above.
Make sure that the date and time of this media server matches the date and
■
time on the master server.
The following procedure describes how to configure a new or a re-imaged appliance
from the NetBackup Appliance Web Console.
Caution: Before or immediately after initial configuration, change the default
maintenance password (
provided to Veritas Technical Support in case you need future troubleshooting
assistance. Change the maintenance password through the NetBackup Appliance
Shell Menu with one of the following commands:
or
maintenance Main > Support > Maintenance > passwd
information, see the NetBackup Appliance Command Reference Guide.
To perform the initial configuration on a NetBackup 52xx appliance from the
NetBackup Appliance Web Console
1
On the laptop that is connected to the NIC1 appliance port, navigate to the
Local Area Connection Properties dialog box.
On the General tab, select Internet Protocol (TCP/IP) so that it is highlighted,
then click Properties.
) for the appliance. This password must be
P@ssw0rd
Initial configuration procedures
Main > Settings > Password
. For complete
32