VERITAS NetBackup 5230 Configuration Manual page 53

Performing the initial configuration on a 52xx master server appliance from the NetBackup Appliance Shell
Configure the gateway
address for each network that
you added
5
From the Main_Menu > Network view, use the following command to set the
appliance DNS domain name.
Note: If you do not use DNS, then you can proceed to Step 8.
DNS Domain Name
Where Name is the new domain name for the appliance.
6
From the Main_Menu > Network view, use the following command to add the
DNS name server to your appliance configuration.
DNS Add NameServer IPAddress
Where IPAddress is the IP address of the DNS server.
The address can be either IPv4 or IPv6. Only global-scope and unique-local
IPv6 addresses are allowed.
See "About IPv4-IPv6-based network support"
To add multiple IP addresses, use a comma to separate each address and no
space.
7
From the Main_Menu > Network view, use the following command to add a
DNS search domain to your appliance configuration so the appliance can
resolve the host names that are in different domains:
DNS Add SearchDomain SearchDomain
Where SearchDomain is the target domain to add for searching.
Gateway Add GatewayIPAddress
[TargetNetworkIPAddress] [Netmask]
[InterfaceName]
Where GatewayIPAddress is the gateway for the
interface and TargetNetworkIPAddress, Netmask, and
InterfaceName are optional. Repeat this command
to add the gateway to all of the destination networks.
The Gateway IP Address or the
TargetNetworkIPAddress can be an IPv4 or an IPv6
address.
Remember that you should not use both IPv4 and IPv6
address in the same command. For example, you
cannot use Gateway Add 9ffe::3 255.255.255.0
eth1. You should use Gateway Add 9ffe::3
6ffe:: 64 eth1.
on page 12.
Initial configuration procedures 53
Menu