Call Home Configuration Data Entry Fields - VERITAS NetBackup 5230 Configuration Manual

Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console
You can configure this server to send email reports to a proxy server or to the
Veritas Call Home server.
The following describes the supported proxy servers:
Squid
■
Apache
■
TMG
■
Note: NTLM authentication in the proxy configuration is also supported.
For Call Home, enter the appropriate Call Home Configuration information
as follows:

Call Home Configuration data entry fields

To configure the appliance to send email reports to a proxy server or to the Veritas
Call Home server, enter the following information:
Enable Call Home
■
Click this check box to enable the appliance to send email reports to the Veritas
Call Home server.
Enable proxy server
■
Click this check box to use a proxy server for email notification and provide the
proxy information that follows.
Enable proxy Tunneling
■
To enable proxy tunneling, click this check box and provide the following proxy
information:
Proxy server
■
Enter the IP address of the server.
The IP address can be either IPv4 or IPv6. For IPv6, only global-scope and
unique-local addresses are allowed.
Proxy port
■
Enter the port number of the proxy server to allow communication with this
appliance.
Proxy username
■
Enter the user name for the proxy server.
Proxy password
■
Enter the password of the proxy server.
Test Call Home
■
After you have entered all of the necessary information, Veritas recommends
that you click Test Call Home to verify communication with the Veritas server.
If the test fails, check that you have entered all names, IP addresses, and port
numbers correctly. If the test fails again, contact Veritas Technical Support.
Initial configuration procedures 43