VERITAS NetBackup 5230 Configuration Manual page 35

Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console
Verify that all units are turned on and have booted up completely.
■
Verify that you have checked all of the items on the hardware check list.
■
After you have verified the previous items, click Rescan.
■
When all connected devices are displayed, click Next to start the initial
configuration.
Note: If you cannot get all devices to display after verifying all of the previous
items and rescanning, contact Veritas Technical Support.
6
The Network Configuration page contains the following taskbars to complete
specific tasks with their necessary data entry fields to configure network
connectivity. Expand taskbar to enter the relevant network configuration
information:
Create Bond - Use to create a bond between two or more network
■
interfaces.
Tag VLAN - Starting with NetBackup Appliances version 2.6.0.3, you can
■
configure VLANs in your existing network environments using this taskbar.
Add Static Route - Use to add a route configuration for your network.
■
Note: These functions are independent of the other and do not require
configuration in the order in which they appear.
Enter the appropriate Create Bond information as follows:
Initial configuration procedures 35