Network Configuration - Create Bond; Network Configuration - Tag Vlan; Network Configuration - Add Static Route - VERITAS NetBackup 5230 Configuration Manual

Use this checklist together with the initial configuration procedures in the NetBackup
Hardware Installation and Configuration Guide. That document also contains a copy
of this checklist.
For a new appliance, use the following tables to record the initial configuration
settings for this appliance. If this appliance is ever factory reset or re-imaged, the
appliance must be configured again. The recorded settings in the checklist can
save valuable time and help get the appliance back on line quickly.
When using the hard copy or printed version of this checklist, make sure to place
the completed checklist in a secure location. You can also obtain a PDF version of
the checklist to download and save to a location of your choice. To access the latest
version of this checklist, see the following link:
www.symantec.com/docs/DOC6675

Network Configuration - Create Bond

Table 1-4
Field
Network Interface
Bond Mode
IP Address
Subnet Mask

Network Configuration - Tag VLAN

Table 1-5
Field
Select Interface
Description (for Select Interface field above)
VLAN Id
IP Address (IPv4 or IPv6)
Subnet Mask

Network Configuration - Add Static Route

Table 1-6
Field
Destination IP
Destination Subnet Mask
Preparing for initial configuration
NetBackup appliance initial configuration checklist
Setting
Setting
Setting
26