Table of Contents
Advertisement
Configure the control panel for IP communication
If you want the Security Center server to communicate with the local Galaxy Dimension control
panel using IP communication, you must configure the Ethernet module E080-4
communication settings on the control panel.
For more information about configuring the Ethernet module, see your Honeywell
documentation.
NOTE
If you are using RS-232 communication, you do not need to perform these steps. See
"Configure the control panel for RS-232 communication"
Before you begin:
version 3.02.
Set the
1
For more information about setting the module IP address, see "56.4.1.1 IP Address" in the
Honeywell Galaxy Dimension Installer Manual.
2
Set the alarm signalling
SIA level 4 allows Security Center to control the Galaxy Dimension control panel.
For more information about programming the SIA format, see "56.4.2.1 = SIA (0-4)
Security Industries Association" in the Honeywell Galaxy Dimension Installer Manual.
3
Using a keypad on your control panel, set the trigger event status to On.
Repeat step
4
5
Set the destination
By default, the Security Center port number is 10002.
For more information about configuring the Primary IP's IP address and port number, see
"56.4.2.2 - Primary IP" in the Honeywell Galaxy Dimension Installer Manual.
6
Create the
The account number must be a unique number that identifies the site. It can have up to six
digits.
Best practice:
For more information about creating an account number, see "56.4.2.4 - Account No. " in the
Honeywell Galaxy Dimension Installer Manual.
7
Using a keypad on your control panel, set the destination
Selecting
For more information about setting the Receiver option, see "56.4.2.5 - Receiver" in the
Honeywell Galaxy Dimension Installer Manual.
8
Set the
For more information about setting the protocol, see "56.4.2.8 - Protocol" in the Honeywell
Galaxy Dimension Installer Manual.
Configure the
9
gtap.genetec.com | Honeywell Galaxy Control Panel Integration Guide 5.2
EN.550.007-V5.2.C4(3) | Last updated: March 11, 2014
Install the Honeywell Galaxy Ethernet module E080-4 with firmware
of the Ethernet module.
IP Address
Format
Step 3
for each trigger event.
IP address
and
Account Number (Account No.).
Do not start the account number with a zero.
Single
indicates that the Primary IP destination is used for signalling alarms.
Protocol
format to
TCP
settings for the control panel.
Remote access
on page 15.
as SIA, and the
SIA level
Port number
of Security Center.
(Transmission Control Protocol).
Preconfiguration checklist
to level 4.
Receiver
option to Single.
17
Hide quick links:
Advertisement
Table of Contents
