Honeywell Galaxy Dimension series Integration Manual page 30

When you synchronize the clocks, the time is set to the control panel's local time zone.
NOTE
4 In the Input pins and output pins
You can select an entire panel Line, or individual inputs and outputs.
NOTE The number of inputs and outputs depends on the type of panel you have. For a list
of Galaxy Dimension control panels supported in Security Center, see
Galaxy devices"
5 (Optional) Configure the
and Security Center server. See
6 In the Intrusion detection areas
a Select the
The Intrusion detection areas are the groups you configured on the control panel.
IMPORTANT
automatically part of the same group. For more information about enabling/disabling the
Group option, see "63.1=Groups" in the Honeywell Galaxy Dimension Installer Manual.
b From the
detection area.
If the "Trigger intrusion alarm" action is triggered on that intrusion detection area from
Security Desk, the input you select is activated, and can initiate another action on the
panel (depending on your panel configuration).
IMPORTANT
(group) on the control panel. For more information about configuring groups on your
control panel, see "52.10=Group" in the Honeywell Galaxy Dimension Installer Manual.
Best practice:
on the panel is immediate. If the input you select has the Exit, Entry, or Final input func-
tion, an entry/exit delay is applied to any action.
7 (Optional) In the
from a keypad on the panel. See
In the
8 Peripheral mappings
detection areas.
Configuring the peripheral mappings is helpful when receiving duress events in Security
Center. For example, if someone sends a duress event from a keypad to Security Center, you
will know which keypad sent the event by its ID, and where the keypad is located by the
intrusion detection area it is mapped to.
gtap.genetec.com | Honeywell Galaxy Control Panel Integration Guide 5.2
EN.550.007-V5.2.C4(3) | Last updated: March 11, 2014
section, select the inputs and output pins to monitor.
on page 8.
Heartbeat input
"Configuring the heartbeat connection"
section, do the following:
Intrusion detection areas
If the Group option is disabled on the control panel, all inputs are
Intrusion alarm input drop-down list, assign an input to the intrusion
The input you select must already be part of that intrusion detection area
Select an input with the Intruder function so the resulting action triggered
Custom event mappings
"Map inputs to intrusion detection areas"
section, map peripheral devices (keypads) to intrusion
Configuring the intrusion detection unit
to monitor the connection between the panel
to monitor in Security Desk.
section, create custom events you can trigger
"Supported Honeywell
on page 30.
on page 27.
25