Example For Outputting The Debugging Information To The Console; Figure 2-9 Networking Diagram Of Outputting Information To The Console - Huawei Quidway S9300 Configuration Manual

2 Information Center Configuration
Configuration Files
#
sysname Quidway
#
info-center source IP channel 7 trap level informational
info-center snmp channel 7
#
interface GigabitEthernet1/0/0
undo shutdown
ip address 10.1.1.2 255.255.255.0
#
snmp-agent
snmp-agent local-engineid 000007DB7F00000100003598
snmp-agent community write
snmp-agent community read
snmp-agent community write
snmp-agent sys-info version v2c v3
snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname public
snmp-agent trap enable
#
return
2.6.6 Example for Outputting the Debugging Information to the
Console
After debugging messages are configured to be output to the console, when a fault occurs on the
device and you can log in to the device through the console and run the debugging command to
view debugging messages.
Networking Requirements
As shown in
Resolution Protocol (ARP) module to the Console.

Figure 2-9 Networking diagram of outputting information to the Console

Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
2-46
Figure 2-9, it is required to output the debugging information of the Address
Console
Switch
Enable the information center.
Set the logs to be output to the Console and the information source.
Configure the channel through which the debugging information is output.
Enable the terminal monitor function and display the debugging information.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide - Device Management
write
public
private
PC
Quidway S9300 Terabit Routing Switch
Issue 01 (2010-12-15)