Optional) Naming The Information Channel; Outputting Debugging Information To The Log File - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
info-center enable
The information center is enabled.
By default, the information center is enabled.
----End

2.4.3 (Optional) Naming the Information Channel

Naming information channels helps you understand what is output by each channel.
Context
Do as follows on the switch configured with the information center.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
info-center channel channel-number name channel-name
The name of the specified channel is set.
----End

2.4.4 Outputting Debugging Information to the Log File

When a fault occurs on the device, you can analyze the output debugging messages to provide
references for fault location.
Context
Do as follows on the switch configured with the information center:
Procedure
Step 1 Configuring Debugging Information to Be Output Through the Channel
1.
2.
Issue 01 (2010-12-15)
Run:
system-view
The system view is displayed.
Run:
info-center source { module-name | default } channel { channel-number | channel-
name } [ debug { state { off | on } | level severity } * ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Information Center Configuration
2-27