Configuration Web Interface; Start; Information - TagMaster XT-1 Manual

XT-1/XT Mini Manual 13-111 05, 2015-08-14
4 Configuration
Web Interface
The reader has a web interface for configuration and maintenance. The web interface is designed and
tested to work with Google Chrome 34, Microsoft Internet Explorer 10, and Mozilla Firefox 28.
Figure 18 Web interface with expanded menu
Connect to the web interface by entering the reader's IP address in the web browser's address bar.
The reader's default IP address can be found on a label on the backside of the reader. The address is on
the format 10.x.x.x with subnet mask 255.0.0.0. It is also possible to force the reader to use a fixed IP
address by setting DIP switch S101:3 to ON before starting the reader. The IP address will then be
169.254.1.1 and the subnet mask 255.255.0.0. A PC that is directly connected to a reader will usually get
an IP address in this subnet automatically.
If the PC does not have an IP address that is in the same subnet as the reader it is necessary to change
the PC's address. In Windows 7, this is done using "Network and Sharing Center" in "Control Panel". Click
on "Local Area Connection", "Properties", "TCP/IPv4", and "Properties". Select "Use the following IP
address" and fill in "IP address" and "Subnet mask". If the reader has default IP settings, the values
10.0.0.10 and 255.0.0.0 can be used.
Note that the web interface may look slightly different depending on the version of the firmware in the
reader. Up-to-date documentation is always available under "Documentation" in the web interface menu.

4.1.1 Start

The "Start" page provides TagMaster contact information.

4.1.2 Information

The "Information" page provides information about the system.
Page 20 of 32