Wire Connections; Spring Cage Terminals; Ethernet And Usb - TagMaster XT-1 Manual

XT-1/XT Mini Manual

Wire Connections

2.5.1 Spring Cage Terminals

With the exception of Ethernet and USB, all wires are connected to spring cage terminals.
These terminals are easy to use and work with both solid and stranded wires.
Instructions
1.
2.
3.
4.
5.
Wire size
Table 1 Wire connection overview

2.5.2 Ethernet and USB

Ethernet connections are made with standard RJ45 connectors. Make sure to pass the Ethernet cable
through the cable gland before crimping the connector to the cable.
USB is intended for service and maintenance and is therefore connected only when the lid is open.
Connection is done using a standard USB type B cable.
Strip wire lead approximately 9 mm.
Push screwdriver down to release spring cage.
Insert wire into terminal.
Remove screwdriver to clamp wire.
Gently pull installed wire to make sure connection is reliable.
2
0.5 mm - 1.5 mm
2
(AWG 20 - AWG 16)
13-111 05, 2015-08-14
Page 10 of 32