Troubleshooting; Definitions And Abbreviations; References - TagMaster XT-1 Manual

XT-1/XT Mini Manual

7 Troubleshooting

To facilitate troubleshooting, consider the following:
Make sure that the reader has correct supply voltage and sufficient current. Check the small green
LED on the controller board inside the reader. When the LED is flashing (once per second) the
reader is powered and the firmware is running. If the LED is on, but not flashing, the reader is
powered but the firmware is not running. If the LED is off, the reader is not powered.
If using Ethernet communication, make sure that the network connection is ok. There are small
LEDs on or close to the RJ45 socket, only visible when the lid of the reader is open. A yellow light
indicates 'Link' and a flashing yellow light indicates 'Activity'.
If the IP address has been forgotten or firmware settings have been corrupted the reader can be
restored to factory default settings as described in section 4.5.
Make sure that working and correctly formatted EPC Gen 2 tags are being used.

8 Definitions and Abbreviations

AES
ASCII
AWG
CR
DES
DIP
EPC
FCC
LED
LF
OEM
RFID
PC
®
SecureMarkID
TAGP
TCP/IP
UMK
USB

9 References

[1] 06-147 UMK 193600 D
[2] 05-172 TAGP P
[3] EPC G 2 S
EN
[4] SIA O S
PEN UPERVISED
Manuals and documentation can be downloaded from www.tagmaster.com.
Advanced encryption standard
American standard code for information interchange
American wire gauge
Carriage return
Data encryption standard
Dual in-line package
Electronic product code
Federal communications commission
Light emitting diode
Line feed
Original equipment manufacturer
Radio-frequency identification
Personal computer
A TagMaster implementation for improved Security using EPC tags
A TagMaster protocol for RFID reader communication
An Internet protocol suite
Universal mounting kit
Universal serial bus
S
ATA HEET
S
ROTOCOL PECIFICATION
.2.0.1,
PECIFICATION V
D P
EVICE ROTOCOL
:// . 1.
HTTP WWW GS ORG
, :// .
HTTP WWW SIAONLINE
13-111 05, 2015-08-14
.
ORG
Page 30 of 32