Wiegand/Magstripe - TagMaster XT-1 Manual

XT-1/XT Mini Manual

Wiegand/Magstripe

The reader has a software configurable Wiegand/Magstripe interface.
Connections
(Wiegand)
Connections
(Magstripe)
Max cable length
Wire size
Voltage
Sink current
Isolation
Table 4 Wiegand connection overview
All Wiegand/Magstripe settings are available under Settings.../Interfaces.../Wieg/Mag in the web interface.
It is possible to select a predefined format or define a custom format.
The most common predefined formats can be selected by setting DIP switches S101:6-8 as shown in the
table below. When any of these switches are in the ON position, the reader is also configured to report tags
once and only accept SecureMarkID tags.
The following formats can be selected by DIP switches:
D = Data from tag (bit for Wiegand/digit for Magstripe)
S = Value of Site code
E = Even parity bit, O = Odd parity bit, X = Bit included in parity calculation
B = Magstripe start character, F = Magstripe stop character, L = Magstripe LRC
Output Format
W26S/H10301
S101
1 8
W26N/H10301
S101
1 8
W34N
S101
1 8
WIEG:D0
WIEG:D1
WIEG:CL
WIEG:GND
MAG:CLK
MAG:DATA
MAG:LOAD
MAG:GND
100 m (depending on properties of receiving system)
2
0.5 mm (AWG 20), 1.5 mm
Typ 5 V / Max 30 V
Max 500 mA
Min 1500 VDC
Description
26-bit Wiegand (8-bit site code, 16-bit data):
ESSSSSSSSDDDDDDDDDDDDDDDDO
ON
XXXXXXXXXXXXX-------------
-------------XXXXXXXXXXXXX
26-bit Wiegand (24-bit data, no site code):
EDDDDDDDDDDDDDDDDDDDDDDDDO
ON
XXXXXXXXXXXXX-------------
-------------XXXXXXXXXXXXX
34-bit Wiegand (32-bit data, no site code):
EDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDO
ON
XXXXXXXXXXXXXXXXX-----------------
-----------------XXXXXXXXXXXXXXXXX
Wiegand 0
Wiegand 1
Card load
Signal ground #1
Magstripe clock
Magstripe data
Card load
Signal ground #1
2
(AWG 16) above 10 m of length.
13-111 05, 2015-08-14
Page 12 of 32