Installing The Optical Drive Cage Or Tape Drive - Dell EMC PowerEdge T640 Installation And Service Manual

NOTE: Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certification of the system.
The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. Perform
the same steps to install blanks.
Figure 50. Removing the optical drive cage or tape drive
Next step
Install the optical drive cage or tape drive.
Related link
Removing the front bezel

Installing the optical drive cage or tape drive

Installing the optical drive cage or tape drive
Prerequisite
NOTE: The procedure to install the optical drive cage is the same as installing the tape drive.
Follow the safety guidelines listed in
Steps
1 Unpack and prepare the drive for installation.
For instructions, see the documentation that shipped with the drive.
If you are installing a SAS tape drive, you must have an internal tape adapter installed. For more information on installing a SAS tape
drive, see the Installing an expansion card
2 If applicable, remove the existing drive or the drive blank.
3 Align the guide on the drive with the slot on drive bay.
4 Slide the drive into the slot until the latch clicks into place.
5 Connect the power and data cable to the drive.
6 Connect the power and data cables to the backplane and the system board.
Safety instructions.
section.
Installing and removing system components 105