Caster Wheels - Optional; Removing Caster Wheels - Dell EMC PowerEdge T640 Installation And Service Manual

Figure 18. Installing the system feet
Next steps
1 Place the system upright on a flat, stable surface, and rotate the system feet outward.
2 Follow the procedure listed in
Caster wheels – optional
Caster wheels provide mobility to the system in the tower mode.
The caster wheel assembly consists of:
• Caster wheel units (front and back)
• Two screws for the caster wheel units

Removing caster wheels

Prerequisites
1 Follow the safety guidelines listed in
2 Place the system on a flat, stable surface.
Steps
1 Using the Phillips #2 screwdriver, loosen the captive screw that secures the front wheel unit to the base of the system.
2 Push the front wheel unit toward the rear of the system to release the retention hooks, and pull out the front wheel unit.
3 Loosen the screw that secures the back wheel unit to the base of the chassis.
4 Push the rear wheel unit toward the front of the system to release the retention hooks, and pull out the rear wheel unit.
70 Installing and removing system components
After working inside your system.
Safety instructions.