Disabling Forgotten Password - Dell EMC PowerEdge T640 Installation And Service Manual

Hide thumbs Also See for EMC PowerEdge T640:
Table of Contents

Advertisement

Disabling forgotten password

The software security features of the system include a system password and a setup password. The password jumper enables or disables
password features and clears any password(s) currently in use.
Prerequisite
Steps
1
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2
Remove the system cover.
3
Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4.
4
Install the system cover.
The existing passwords are not disabled (erased) until the system boots with the jumper on pins 2 and 4. However, before you assign a
new system and/or setup password, you must move the jumper back to pins 4 and 6.
NOTE:
If you assign a new system and/or setup password with the jumper on pins 2 and 4, the system disables the new
password(s) the next time it boots.
5
Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
6
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7
Remove the system cover.
8
Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
9
Install the system cover.
10
Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
11
Assign a new system and/or setup password.
162
Jumpers and connectors

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents