System Cover; Removing The System Cover - Dell EMC PowerEdge T640 Installation And Service Manual

3 Rotate the rubber cap clockwise to fix it over the captive screws.
4 Insert the mating connector into the power supply.

System cover

System cover provides security for the entire system and also helps in maintaining proper air flow inside the system.

Removing the system cover

Prerequisites
1 Follow the safety guidelines listed in
2 Turn off the system and all attached peripherals.
3 Disconnect the system from the electrical outlet and peripherals.
4 If installed, remove the front bezel.
5 Place the system on a flat, stable surface.
Steps
1 Turn the latch release lock to the unlocked position.
2 Press the cover release latch and remove the system cover.
Figure 35. Removing the system cover
Next step
Install the system cover.
Related link
Removing the front bezel
Installing the system cover
Safety instructions.
Installing and removing system components 89