Idrac Direct Led Indicator Codes; Idrac Quick Sync 2 Indicator Codes - Dell EMC PowerEdge T640 Installation And Service Manual

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. The
following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 3. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and off for two
seconds)
Turns off

iDRAC Quick Sync 2 indicator codes

iDRAC Quick Sync 2 module (optional) is located on the front panel of your system.
Figure 6. iDRAC Quick Sync 2 indicator
Table 4. iDRAC Quick Sync 2 indicators and descriptions
iDRAC Quick Sync 2 indicator
code
Off (default state)
Solid white
Blinks white rapidly
Blinks white slowly
Blinks white five times rapidly and
then turns off
16 Dell PowerEdge T640 overview
Condition
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Condition
Indicates that the iDRAC Quick Sync 2
feature is turned off. Press the iDRAC Quick
Sync 2 button to turn on the iDRAC Quick
Sync 2 feature.
Indicates that iDRAC Quick Sync 2 is ready
to communicate. Press the iDRAC Quick
Sync 2 button to turn off.
Indicates data transfer activity.
Indicates that firmware update is in
progress.
Indicates that the iDRAC Quick Sync 2
feature is disabled.
Corrective action
If the LED fails to turn on, reseat the cable and check.
If the problem persists, see the Getting help section.
If the LED fails to turn off, restart the system. If the
problem persists, see the Getting help section.
If the indicator continues to blink indefinitely, see the
Getting help section.
If the indicator continues to blink indefinitely, see the
Getting help section.
Check if iDRAC Quick Sync 2 feature is configured to
be disabled by iDRAC. If the problem persists, see the
Getting help section. For more information, see
Integrated Dell Remote Access Controller User's