Installing The Air Shroud - Dell EMC PowerEdge T640 Installation And Service Manual

Figure 38. Removing the air shroud
Next step
Install the air shroud.
Related link
Removing a cooling fan

Installing the air shroud

Installing the air shroud
Prerequisites
1 Follow the safety guidelines listed in
2 If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing bracket.
Steps
1 Align the tabs on the air shroud with the securing slots on the chassis.
a Guide on the air shroud with the guide pin on the system board.
b Align the intrusion switch with the intrusion switch connector on the system board.
2 Lower the air shroud into the chassis until it is firmly seated.
When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
3
NOTE: The procedure to install the cooling fan into the air shroud is similar to installing a cooling fan.
If removed, install the fans into the air shroud.
Safety instructions.
Installing and removing system components 93