Table of Contents
Advertisement
Installing the storage controller card
Prerequisite
Follow the safety guidelines listed in
Steps
1
Align the slots on the edge of the storage controller card with the tabs on the support bracket.
CAUTION:
To prevent damage to the storage controller card, you must hold the card only by its edges.
2
Lower the storage controller card onto the connector on the system board.
3
Using the Phillips #2 screwdriver, tighten the retention screws on the drive backplane cable connector to secure the card to the
system board.
Figure 40. Installing the storage controller card
Next steps
1
Install the following:
a
Drive backplane
b
Drive cage
c
Drives
2
Follow the procedure listed in
Related link
Installing the drive backplane
Installing the drive cage
Installing a drive carrier
84
Installing and removing system components
Safety
instructions.
After working inside your
system.
Advertisement
Table of Contents
