Removing The System From The Enclosure - Dell PowerEdge FC640 Installation And Service Manual

Removing the system from the enclosure

Prerequisites
1 Follow the safety guidelines listed in
2 Turn off the system.
Steps
1 Press the release button on the system handle to release the handle.
2 Holding the system handle, slide the system out of the enclosure.
CAUTION: To protect the I/O connector pins, install the I/O connector cover every time a system is removed from the
enclosure.
Figure 6. Removing the system from the enclosure
3 Install the I/O connector cover over the I/O connector.
Safety instructions.
Installing and removing system components 49