Installing the Network Daughter Card
Prerequisite
CAUTION:
To prevent damage to the Network Daughter Card (NDC), you must hold the card only by its edges.
1
Follow the safety guidelines listed in
Steps
1
Align the following:
a
The slots on the card edge with the projection tabs on the plastic bracket covering the NDC slots.
b Screw holes on the card with the standoffs on the system board.
2
Lower the card into place until the card connector fits into the corresponding connector on the system board.
3
Using the Phillips #2 screwdriver, replace the screws to secure the card.
Figure 36. Installing the Network Daughter Card
Next steps
1
Install the PCIe mezzanine card.
2
Follow the procedure listed in
Mezzanine card
The PowerEdge M640 supports SFF mezzanine cards. x8 PCIe Generation 3 cards are supported.
80
Installing and removing system components
Safety
instructions.
After working inside your
system.