Viewing System Setup; System Setup Details - Dell PowerEdge FC640 Installation And Service Manual

Viewing System Setup

To view the System Setup screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
Related link
System Setup

System Setup details

System Setup details
The System Setup Main Menu screen details are explained as follows:
Option Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see Integrated Dell Remote Access Controller User's Guide at
Dell.com/idracmanuals.
Device Settings Enables you to configure device settings.
Related link
System Setup
iDRAC Settings utility
Device Settings
Viewing System Setup
24 Pre-operating system management applications