Displaying And Maintaining Ssh; Stelnet Configuration Examples; Password Authentication Enabled Stelnet Server Configuration Example - HP FlexFabric 5700 Series Security Configuration Manual

Displaying and maintaining SSH

Execute display commands in any view.
Task
Display the source IP address configured for the
SFTP client.
Display the source IP address configured for the
Stelnet client.
Display SSH server status or sessions.
Display SSH user information on the SSH
server.
Display the public keys of the local key pairs.
Display the public keys of the SSH peers.

Stelnet configuration examples

Unless otherwise noted, devices in the configuration examples are in non-FIPS mode.
When you configure Stelnet on a device that operates in FIPS mode, follow these restrictions and
guidelines:
The modulus length of the key pair must be 2048 bits.
•
• When the device acts as an Stelnet server, only RSA and ECDSA key pairs are supported.
Password authentication enabled Stelnet server configuration
example
Network requirements
As shown in
You can log in to Switch through the Stelnet client that runs on the host.
•
• After login, you are assigned the user role network-admin for configuration management.
The switch acts as the Stelnet server and uses password authentication.
•
• The username and password of the client are saved on the switch.
Figure 87 Network diagram
Stelnet client
192.168.1.56/24
Host
Figure 87:
Vlan-int2
192.168.1.40/24
Command
display sftp client source
display ssh client source
display ssh server { session | status }
display ssh user-information [ username ]
display public-key local { dsa | ecdsa | rsa } public [ name
publickey-name ]
display public-key peer [ brief | name publickey-name ]
Stelnet server
Switch
317