Displaying And Maintaining Mff; Mff Configuration Examples; Manual-Mode Mff Configuration Example In A Tree Network - HP FlexFabric 5700 Series Security Configuration Manual

Step
1. Enter system view.
2. Enter VLAN view.
3. Specify the IP addresses of
servers.

Displaying and maintaining MFF

Execute display commands in any view.
Task
Display MFF port configuration information.
Display the MFF configuration information for a VLAN.

MFF configuration examples

Manual-mode MFF configuration example in a tree network

Network requirements
As shown in
manually.
Configure MFF to isolate the hosts at Layer 2 and allow them to communicate with each other through
Gateway at Layer 3.
Figure 118 Network diagram
Configuration procedure
1. Configure the IP addresses of the hosts and Gateway as shown in
2. Configure Switch A:
Command
system-view
vlan vlan-id
mac-forced-forwarding server
server-ip&<1-10>
Figure 1 18, all the devices are in VLAN 100. Hosts A, B, and C are assigned IP addresses
Command
display mac-forced-forwarding interface
display mac-forced-forwarding vlan vlan-id
379
Remarks
N/A
N/A
By default, no server IP address is
specified.
Figure 118.