Configuring A Static Ipv6Sg Binding; Displaying And Maintaining Ipsg - HP FlexFabric 5700 Series Security Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. Enable the IPv6SG feature.

Configuring a static IPv6SG binding

You can configure global static and interface-specific static IPv6SG bindings.
Global static bindings take effect on all interfaces.
Interface-specific static bindings take priority over global static bindings. An interface first uses the static
bindings on the interface to match packets. If no match is found, the interface uses the global bindings.
Configuring a global static IPv6SG binding
Step
1. Enter system view.
2. Configure a global
static IPv6SG binding.
Configuring a static IPv6SG binding on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Configure a static
IPv6SG binding.

Displaying and maintaining IPSG

Execute display commands in any view and reset commands in user view.
Command
system-view
interface interface-type
interface-number
ipv6 verify source { ip-address |
ip-address mac-address |
mac-address }
Command
system-view
ipv6 source binding ip-address ipv6-address
mac-address mac-address
Command
system-view
interface interface-type
interface-number
ipv6 source binding { ip-address
ipv6-address | ip-address
ipv6-address mac-address
mac-address | mac-address
mac-address } [ vlan vlan-id ]
350
Remarks
N/A
The following interface types are
supported:
•
Layer 2 Ethernet interface.
•
VLAN interface.
By default, the IPv6SG feature is
disabled on an interface.
If you configure this command on
an interface multiple times, the
most recent configuration takes
effect.
Remarks
N/A
No global static IPv6SG
binding exists.
Remarks
N/A
The following interface types are supported:
•
Layer 2 Ethernet interface.
•
VLAN interface.
By default, no static IPv6SG binding is
configured on an interface.
The vlan vlan-id option is supported only in
Layer 2 Ethernet interface view.
You can configure the same static IPv6SG
binding on different interfaces.