Enabling Portal Roaming; Logging Out Portal Users; Displaying And Maintaining Portal - HP FlexFabric 5700 Series Security Configuration Manual

Enabling portal roaming

Portal roaming takes effect only on portal users logging in from VLAN interfaces.
If portal roaming is enabled on a VLAN interface, an online portal user can access resources from any
Layer 2 port in the VLAN without re-authentication.
If portal roaming is disabled, to access external network resources from a Layer 2 port different from the
current access port in the VLAN, the user must do the following:
• First log out from the current port.
Then re-authenticate on the new Layer 2 port.
•
To enable portal roaming:
Step
1. Enter system view.
2. Enable portal roaming.

Logging out portal users

Logging out a user terminates the authentication process for the user or removes the user from the
authenticated users list.
To log out users:
Step
1. Enter system view.
2. Log out IPv4 portal users.
3. Log out IPv6 portal users.

Displaying and maintaining portal

Execute display commands in any view and the reset command in user view.
Task
Display portal rules on an interface.
Command
system-view
portal roaming enable
Command
system-view
portal delete-user { ipv4-address | all | interface interface-type
interface-number }
portal delete-user { all | interface interface-type interface-number |
ipv6 ipv6-address }
Command
display portal rule { all | dynamic | static } interface
interface-type interface-number [ slot slot-id ]
136
Remarks
N/A
By default, portal roaming is
disabled.
You cannot enable portal roaming
when login users exist on the
device.