Entering Your Cell's Path Length - Agilent Technologies Cary 8454 Operator's Manual

5 Using your UV-Visible Spectroscopy System

Entering your Cell's Path Length

Entering your Cell's Path Length

The cells used for your measurements are specified with the sampling system
parameters. In quantitative calculations, these parameters are used in results
calculations. You must provide the correct value for the path length setting.
Usually you get this information from the supplier of your cells. You set the
path length in manual mode cell handling as follows.
1 Click Setup on the Instrument Panel.
2 Type the path length in cm in the Setup Manual dialog box.
3 Click OK to set the specified path length.
92 Agilent Cary 8454 UV-Visible Spectroscopy System Operator's Manual