The Indicated Ends Of The Top Frame (8 - ICON Health & Fitness Weider 9000 User Manual

7. Slide the Carriage Stop (19) onto the Rear
Upright (6). Make sure that the Carriage Stop is
oriented so the Carriage Stop Bushing (20)
and the indicated hole are in the positions
shown. Attach the Carriage Stop to the hole near
the bottom of the Rear Upright with an M8 x
70mm Bolt (58) and an M8 Nylon Locknut (48).
Press two 25mm Round Inner Caps (45) into the
tube on the Weight Carriage (10). Insert an M10 x
19mm Bolt (61) into the bracket on the Weight
Carriage. Slide the Weight Carriage onto the Rear
Upright (6). Be sure the bracket is on the side
shown.
8. Press three 50mm Square Inner Caps (43) into

the indicated ends of the Top Frame (8).

9. Attach the Top Frame (8) to the Crossbar (7) with
two M10 x 68mm Bolts (46), two M10 Washers
(52), and two M10 Nylon Locknuts (49).
Attach the Top Frame (8) to the Centre Upright
(5) with two M10 x 68mm Bolts (46), two M10
Washers (52) and two M10 Nylon Locknuts (49).
Do not tighten the M10 Nylon Locknuts (49)
yet.
10. Attach the Top Frame (8) to the Rear Upright (6)
with three M10 x 68mm Bolts (46), two Support
Plates (14), and three M10 Nylon Locknuts (49).
Tighten the M10 Nylon Locknuts (49) used in
steps 2–10.
7
45
10
45
61
20
19
Hole
48
6
58
8
43
8
43
43
9
46
52
46
8
49
49
7
5
52
49
10
14
49
14
8
46
6
8
ATTACHING THE LAT BAR TO THE HIGH PULLEY
STATION OR THE LOW PULLEY STATION
To use the high or low pulley station, attach the Lat
Bar (73) to the High Cable (31) or the Low Cable (not
shown) using a Cable Clip (30). The Row Bar (not
shown) can be attached in the same manner.
WARNING:
Always remove the Lat
Bar (73) when performing an exercise that does
not require the use of the Lat Bar.
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
To use the Weight Carriage (10), slide the desired
amount of weight (not included) onto each side of the
weight tube on the Weight Carriage. Secure the
weight with the two Weight Pins (37).
WARNING:
Do not place more than
68 kg (150 lbs.) on the Weight Carriage (10).
Always place the same amount of weight on
each side of the Weight Carriage.
To use Olympic weights, press two Adapter Bushings
(44) into the ends of each Weight Adapter (23). Slide
a Weight Adapter onto each side of the weight tube
on the Weight Carriage (10).
STORING WEIGHTS
To store weights, slide them onto the Storage Tubes
(22) on the Right and Left Bases (1, 2).
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (66), slide the desired amount
of weight (not included) onto the Weight Tube (65)
and secure it with the Weight Pin (37).
To use Olympic weights, slide the Weight Adapter
(23) onto the Weight Tube (65).
WARNING:
Do not place more than
68 kg (150 lbs.) on the Weight Tube (65).
31
30
73
10
37
23
Weight
Tube
22
1
2
22
66
37
23
65
17