Table of Contents
Advertisement
CABLE DIAGRAMS
The cable diagrams below show the proper routing of the High Cable (31), the Butterfly Cable (32), and the Low
Cable (33). Use the diagram to make sure that the cables and the cable traps have been assembled correctly. If
the cables have not been correctly routed, the weight bench will not function properly and damage may occur.
The numbers show the correct route for each cable. Make sure that the cable traps do not touch or bind the
cables.
Butterfly Cable (32)
4
2
5
1
3
2
Low Cable (33)
1
3
4
2
3
1
High Cable (31)
4
5
5
20
ASSEMBLY
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight bench has many
parts and that the assembly process will take
time. Most people find that by setting aside plen-
ty of time, assembly will go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
Rack Assembly
1.
Before beginning assembly, be sure that
you have read and understand the infor-
mation in the box above.
Press a 50mm Square Inner Cap (43) into the
end of the Right Base (1).
Insert an M10 x 60mm Carriage Bolt (50) up
through the bottom of the Right Base (1). Lay the
Base on the floor.
Repeat this step with the Left Base (2).
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART in the centre of this
manual.
The following tools (not included) are required
for assembly:
• Two adjustable spanners
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet spanners.
1
1
50
43
2
43
5
Advertisement
Table of Contents
