Zoning - Wolf BML Operating Instructions Manual

Zoning

Please note
Multiple zones in one
system
Fig.:
DIP switches on the
control PCB
3063527_201308
Zoning
When more than one CGL is controlled with one programming unit,
the zone for each appliance must be set using the DIP switches
on the control PCB (in the control panel).
If only one zone is to be connected, the following chapter can
be skipped.
Control PCB
Never pull out the coding card X1, otherwise malfunctions may
result.
The three switches on the left hand side of the 4-position DIP switch
can be used to assign the ventilation unit to a zone.
Up to seven zones are possible in one system.
Zone setting
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Zone 7
X1
DIP switches
7