Displays; Acknowledge Faults - Wolf BML Operating Instructions Manual

Displays

Main menu
Back
Displays
Fault ackn.
Basic settings
Time program
Holiday prog
Specialist
Back

Acknowledge faults

Main menu
Back
Displays
Fault ackn.
Basic settings
Time program
Holiday prog
Specialist
Back
3063527_201308
Control level 2 - Displays - Fault acknowledge
Press the r.h. rotary selector to change to control level 2.
Turn the r.h. rotary selector clockwise to select the „Displays"
menu level and confirm the selection by pressing the r.h. rotary
selector again.
You can now display the following values in sequence by
turning the r.h. rotary selector.
Always select the zone first in order to scan its values.
1 Operating mode
2 Current program
3 Extract air temperature
4 Set room heating
5 Outside temperature
6 Actual vent air temperature
7 Set vent air temperature
8 Motor speed
9 Heating mixer
10 Heat recovery
11 Configuration
12 Softwareversion LM x
Softwareversion LM y
Any sensors that are not connected are skipped, as only
available values can be displayed.
Press the r.h. rotary selector to change to control level 2. Turn
the r.h. rotary selector clockwise to select the „Acknowledge
faults" menu level and acknowledge faults by pressing the r.h.
rotary selector again.
After acknowledging faults, the display returns to the standard
mask immediately.
15