Enable Night Ventilation; Time Program - Wolf BML Operating Instructions Manual

Night ventilation enable
Basic settings
Back
Econ temp htg
Backup temp htg
Speed adjust
Setback prog
VA min limit
Nght vent enable
Factory setting: off
Options: off / on

Time program

Time program
Zonenübersicht
Back
Z1 Zone 1
Z2 Zone 2
Back
Time program
Zone 1
Thursday
Friday
Saturday
Sunday
Copy day
Back
Zone 1
Monday
Back
Start time 07 : 00
End time 14 : 00
Start time 07 : 00
End time 14 : 00
Start time 07 : 00
End time 14 : 00
3063527_201308
Control level 2 -
Default settings / time programs
Select and confirm Night ventilation enable using the r.h. rotary
selector. Turn the r.h. rotary selector to set the required control
type (ON / OFF) and press selector to confirm.
Function:
This function is used in summer to supply the room with cool
outdoor air during periods when the system is not switched on by
the time program.
If the room temperature exceeds a certain value, the system is
switched on until the room temperature returns to the set value.
For a more detailed description, see "Additional functions".
This only works in backup mode
This function requires an outside temperature sensor and a
room sensor/extract air sensor.
Press the r.h. rotary selector to change to control level 2.
Turn the r.h. rotary selector clockwise to select the
"Time program" menu and confirm the selection by pressing
the r.h. rotary selector again.
Select the zone for which you want to program the switching times
and confirm by pressing.
Select the day for which you want to program the switching times
and confirm your selection by pressing the r.h. rotary selector again.
Turn the r.h. rotary selector to select the start time and press
selector to confirm.
Turn to set the required switching time and press selector to confirm.
Follow the same procedure for the end time.
You can then turn the r.h. rotary selector further to program switching
times 2-8 in the same way as described above.
When you have programmed all switching times for the selected
day, you can exit the menu with "Back".
Turn the r.h. rotary selector further to select „Copy day" and confirm
the selection by pressing the selector again. You are automatically
taken to the copy area.
The source day of the week is displayed.
Turn the r.h. rotary selector to select the day you programmed
previously and press selector to confirm.
The target day of the week is displayed.
Select the day or block of days to which you want to copy the
switching times and press selector to confirm.
Copy selection: Mo, Tu, We, Th, Fr, Sa, Su
Mo - Th
Mo - Fr
Sa - Su
21