Connecting The Hardware - Mercedes-Benz XENTRY Kit 2 User Manual

12.2 Connecting the hardware

Power supply and data connection
Connection – power supply
The electrical power connection is located on the right
front side, partially angled. The connecting piece of the
power supply is securely hooked up by means of a threaded
connector to the HMS 990 USB Measurement Technology.
With a sufficient supply of power, the POWER lamp lights up
green.
Figure 111: Connection of the power supply to the Measurement Technology
Included in the scope of supply are:
• A power supply unit with standard electrical power cable
• A 12/24 volt connection by means of adapter for
- Cigarette lighter
- 24-volt socket (truck)
• A 12/24 connection by means of banana plug and alligator
clip for the battery
User Guide XENTRY Kit 2, XENTRY Kit MT 2, XENTRY Connect
Connection – data cable (USB)
• The USB cable is connected on the back side of the HMS
990 USB Measurement Technology. The connector of the
USB cable has been pre-installed.
Figure 112: XENTRY 990 USB Measurement Technology
• The USB cable is connected to the left side of the XENTRY
Tab 2.
• After connecting the hardware, start the XENTRY Tab 2
and then the HMS 990 program on the XENTRY Tab 2
desktop.
• A detailed description of the software operation can be
found in the following chapter.
Daimler AG, Item No. 6511 9538 02, Last updated: 09/2014 51