Mercedes-Benz XENTRY Kit 2 User Manual page 15

1. First, select the basis for the configuration.
Figure 15: Selecting the components for the configuration
In case of an initial startup, select "Configure overall sys-
tem".
2. A series of numerous queries follows; please enter
the data and/or make the selections that your
IT administrator has noted on the network questionnaire.
Figure 16: Config Assist dialog sequence for the initial startup
3. After the input has been entered, you can choose whether
the data should first be saved in a file or immediately
applied to the XENTRY Tab 2 and the XENTRY Connect.
Select an option and proceed with the dialogs.
Figure 17: Apply configuration and successful configuration at completion of
Config Assist.
Tip: Save the file so it can also be used for additional de-
vices as a configuration file.
User Guide XENTRY Kit 2, XENTRY Kit MT 2, XENTRY Connect
Now connect the XENTRY Connect with the XENTRY Tab 2
using the provided black Ethernet connecting cable, and
screw on the cable to the XENTRY Tab 2. On completion of
configuration, the XENTRY Connect display or the XENTRY
Control tile will show the message "Configuration success-
fully applied".
The configuration wizard can be ended and the connection
between the two devices separated. To do this, simply dis-
connect the black Ethernet connecting cable from
both devices.
Note: If you work with fixed IP addresses, we generally re-
commend that you set up a configuration via a DHCP server.
From an IT operations perspective, this is the most secure
way to ensure a sound and stable operating environment.
Details on DHCP can be found in the Connectivity Guide.
Note: If you do not use a DHCP server or, due to network
problems, you wish to assign static IP addresses for your
XENTRY Kit 2, you can also carry out the configuration via
XENTRY Control. In this case you must transfer the configu-
ration to the XENTRY Connect by means of a USB memory
stick. To do this, save the configuration file on
a USB memory stick and insert it in XENTRY Connect.
Then check whether the "Ready" icon
XENTRY Connect display and if the XENTRY Connect is shown
in green in XENTRY Control after about 10 seconds.
Figure 18: XENTRY Control Selection Screen
If yes, you may now use the XENTRY Connect to work on
the vehicle together with the XENTRY Tab 2. To do this, click
onto the green XENTRY Connect icon to connect to it.
If no, there are two possible remedies.
Daimler AG, Item No. 6511 9538 02, Last updated: 09/2014
appears in the
15