Display; Upper Section Of The Xentry Connect Display - Mercedes-Benz XENTRY Kit 2 User Manual

Acoustic signal
Depending on the status of the device, the search tone
provides an acoustic signal which differs in terms of length
and repetition frequency. There are several statuses which
are indicated:
Status
Startup process/switched on short
No external power supply is currently present short
Power supply switchover short
Battery is almost empty short
"Key Finder" activated

6.3.3 Display

The display is used to show all information that is relevant to
the user. The display is divided in an upper and lower section.
Figure 36: Display of the XENTRY Connect
a) The upper half of the display serves to show status icons.
These are displayed permanently and updated as required.
They indicate the battery condition, type of connection,
and the operating state of the device.
b) The lower area is used for messages regarding the
properties, name and statuses of the device and
its connections as well as information to explain and
operate the available options.

6.3.4 Upper section of the XENTRY Connect display

Battery icon
The number of bars (zero to four) in the battery can be used
to determine the charge level of the rechargeable battery.
A vehicle or connector shown underneath indicates that the-
re is a connection to the vehicle or another external power
supply, and that the rechargeable batteries are charging. If
there is no external power supply, however, the duration in
minutes until the XENTRY Connect automatically switches to
standby is located beneath the battery icon.
User Guide XENTRY Kit 2, XENTRY Kit MT 2, XENTRY Connect
Sound
1x
1x
1x
3x
3x long
Upper section: Status icons
Lower section:
Additional information
Figure 37: Battery statuses of the XENTRY Connect
Connection icon: connection status and quality
The house display and the 24h icon clearly indicate
which network profile is active.
The house symbolizes the workshop network. The 24h icon
shows that the devices are directly connected, e.g. for break-
down assistance. If a cable is displayed beneath,
this means that the connection has been established using
a cable. If the WLAN icon is displayed, this means that
the connection is wireless.
Figure 38: Network profile statuses of the XENTRY Connect
These symbols indicate the type and quality of connection.
stands for the workshop network profile (connecti-
on via a network)
stands for the Service24h network profile
(direct connection without network, similar
to the current road mode)
stands for a cable connection
(to the XENTRY Tab 2 or the workshop network)
stands for a WLAN connection: the number of
radio waves (one to four) shown in the relevant icon
represents the signal strength of the WLAN signal.
Figure 39: Key to icons: "Workshop", "24h", "LAN" and "WLAN"
Daimler AG, Item No. 6511 9538 02, Last updated: 09/2014 23