Order Startkey - Mercedes-Benz XENTRY Kit 2 User Manual

by calling up the menu in XENTRY Control: Configuration
Check Expert dialog. One further reason may be that

the XENTRY Connect and/or XENTRY Tab 2 have not been
enabled for your workshop network. In this case, ask your IT
manager / workshop network service provider.

5.4 Order StartKey

On completion of configuration, you must order the neces-
sary StartKeys to be able to use the XENTRY system. The
StartKey enables you to use the XENTRY Diagnostics and
XENTRY DAS diagnostic applications. You also require an
additional StartKey to use WIS standalone. Please note that
the use of WIS standalone is only now approved in exceptio-
nal cases. Make sure that an Internet connection
is available and carry out the following steps:
1. Connect to the XENTRY Connect. Start the StartKey Center
using the button on the adjacent Diagnosis desktop.
Figure 29: Diagnosis desktop on the XENTRY Connect
Note: A temporary StartKey is no longer available on the
XENTRY Connect! Please order the StartKey in a timely
manner.
2. Read out the HW ID and system number of your
XENTRY Connect in the "Overview" tab. You require this
information to order the StartKey.
You have the option of saving the values by means of
"Copy" and/or "Save" buttons to save the values and
make it easier for the StartKey order to read them in.
User Guide XENTRY Kit 2, XENTRY Kit MT 2, XENTRY Connect
Figure 30: StartKey Center overview
3. We would like to point out our electronic ordering options
(LOP, LOT) to apply for permanent access authorization
(StartKey). Information on which ordering process is used
in your country (LOP, LOT or ordering through a central
national contact person), is available from the contact
person for access authorization/StartKeys at your
national company.
4. Now open the "StartKeys" tab. You now have three
options for reading the StartKey for XENTRY Diagnostics
into your system.
a) You save the attached file (which you received via email)
on a USB memory stick in the root directory, then insert
it in the XENTRY Tab 2 and read in the StartKey in the
StartKey Center from the USB memory stick.
b) Then open the StartKey Center and click on the "Load
StartKey online" button. The StartKey is then read-in
directly online. For this variant, you must make sure
that the XENTRY Connect has an Internet connection.
c) You manually enter the StartKey.
Figure 31: Screen for entering StartKeys
Daimler AG, Item No. 6511 9538 02, Last updated: 09/2014 19