Expert Mode Initial Startup - Mercedes-Benz XENTRY Kit 2 User Manual

a) The XENTRY Connect icon is shown in gray in XENTRY
Control and the gears flash on the display:
Figure 19: XENTRY Control tile "Not configured"
In this case, repeat configuration as described in these
instructions. Note that ConfigAssist is now no longer
started automatically. Open ConfigAssist using the menu
bar in XENTRY Control in the "Configuration" menu item.
Please contact Diagnosis Support if a subsequent attempt
also fails.
b) XENTRY Connect does not appear any more in the
overview: in this case, check whether both devices are
set to the same network profile: workshop or Service24h
mode. This can be checked in XENTRY Control through
the menu "Network profile"

the gear button on the XENTRY Connect. If the XENTRY
Connect is still not displayed, then prior to reattempting
configuration the XENTRY Connect and the XENTRY Tab 2
must be connected directly using the Ethernet connecting
cable and Service24h mode must be set in each case.
Only then is it possible to perform configuration again
using ConfigAssist.
Note: After removing the black Ethernet connecting cable,
the devices are only connected if the WLAN is activated
and configured, i.e. if WLAN configuration has been execu-
ted in ConfigAssist.
Please contact Diagnosis Support if a subsequent attempt
also fails.

5.2.2 Expert mode initial startup

In contrast to the procedures described above, this initial
startup procedure is not guided and you must enter the
required data yourself. We only recommend using this
procedure if you have extensive technical knowledge and
have already configured such devices in the past. Keep your
workshop-specific network data ready, e.g. the IP address,
network name and key, as these are required to fill in the
screen. This section only explains the differences between
expert configuration and initial startup using ConfigAssist.
The expert dialog is also called using the "Configuration"
menu item in the XENTRY Control software. Then click onto
the blue "Expert configuration" link at the bottom right in
ConfigAssist:
16
Service24h and by using

Figure 20: Accessing the configuration with the Expert dialog
The following window will open:
Figure 21: Expert dialog
The expert dialog is subdivided into the 3 "Workshop",
"XENTRY Tab 2/standard PC" and "XENTRY Connect" tabs.
First switch to the "Workshop" tab at the top and then to the
"WLAN settings" panel. Make sure that the WLAN (global)
is set to "On".
Figure 22: Expert dialog: WLAN settings
Fill in the fields required for your workshop. Enter the
individual values for your workshop in the proxy settings,
search for settings, EPC, WIS/ASRA settings and group