Advertisement
Proaim 7' WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly
Unscrew the locking lever from the Central Post of the jib. Place the Central Post in the
bowl of Tripod Stand and re-tighten the locking mechanism for a secure fit. (as shown in
the picture.)
NOTE: It is important to make sure that the Central Fork is seated in the bowl properly. That
means perpendicular to the tripod bowl. Off axis installation may hamper movement of the jib.
Also you may need the assistance of a grip stand to hold the camera end of the arm during
installation preventing it from falling as it will be front heavy at this point. You may also need
the grip stand or assistance at the rear of the jib when mounting the camera.
Provided are the jib panning control
knobs (as shown in the picture). Loosen
the
knobs
for
movement of the jib and tighten these
knobs to lock the pan movement of the
jib.
NOTE:
Inbuilt bubble leveler is also
provided to check accurate set-up of jib
on uneven surface areas.
Now to extend the rear section of the jib, loosen the Allen bolts with the provided Allen key
and then, loosen the knob as shown in the picture.
the
smooth
pan
4
Advertisement
