Download Print this page

Motorola SVG2500 User Manual page 97

Advertisement

This document is uncontrolled pending incorporation in PDM
10 SVG2500 VPN PAGES
Field
Name
Enable drop-down
Local Endpoint Settings
Address group type
Identity Type
Identity
Description
A generic user-specified name for a group of settings for a single
tunnel.
Once the appropriate tunnel name is entered for the first time, click
Add New Tunnel to create a heading for the tunnel settings selected
from the Tunnel drop-down list. If no name is entered here, the
tunnels are sequentially named 1, 2, 3, and so on.
Once a particular VPN tunnel is named and configured, it can be
left stored and disabled or enabled via the Enable/Disable drop-
down list. Click Apply to make the "Enable/Disable" setting effective.
Set the local VPN access group as one of the following group
types:
Single IP address – for one computer, enter the IP address
for the specific computer
IP address range – for a small range of computers, enter the
starting and ending IP addresses for the group of consecutive
IP address that will have access to the VPN tunnel
IP Subnet – for an entire subnet/network, enter the Subnet
and Mask
For IP address range and IP Subnet enter the starting and ending IP
addresses for the group of consecutive IP address that will have
access to the VPN tunnel.
You can define the local endpoint identity type to automatically use
the WAN IP address of the router or as a user-specified IP address,
fully qualified domain name (FQDN), or e-mail address. This is the
identity that the far endpoint will use for identification of the VPN
termination point and handshake.
The remote VPN endpoint on the other side of the tunnel should
match the settings here for its remote endpoint settings.
Once the identity type is selected, enter the identity string here.
For IP address, enter x.x.x.x.
For FQDN, enter yourdomain.com
For email address identity, enter yourname@yourdomain.com
The remote VPN endpoint on the other side of the tunnel should
match the settings here for its remote endpoint settings.
111

Advertisement

loading