Adding StoreVirtual 3200 storage systems
Adding StoreVirtual 3200 storage systems increases the available storage capacity and provides
additional redundancy and reliability. Adding a new StoreVirtual 3200 storage system is limited to iSCSI
configurations.
Adding a new storage system to an existing configuration
Prerequisites
•
The new storage system must be configured the same as the storage system in the existing
management group and storage pool.
•
The new storage system must not be configured in a management group. Stop the Configuration
Setup process after you configure the network settings.
Procedure
1.
Install the new storage system following the instructions in the HPE StoreVirtual Storage System
Installation Guide.
2.
Use the Configuration Setup to configure the storage system through the Network Configuration
step.
3.
In the Continue Configuration window, click No
4.
Point the web browser to the management IP address that was assigned to one of the storage
controllers during the network setup.
5.
Log in to the storage system with the User Name and Password admin, admin. These credentials
are always used when a storage system is not in a management group.
6.
On the StoreVirtual menu, select Settings
7.
Select General and then select Actions > Add storage systems on the content pane.
Use Add IP address and Discover available systems to discover storage systems on the network.
30
Adding StoreVirtual 3200 storage systems