Limit-Resource Memory - HPE FlexNetwork 10500 series Command Reference Manual

Virtual technologies

Hide thumbs Also See for FlexNetwork 10500 series:

Security command reference (881 pages)

Security configuration manual (702 pages)

Network management and monitoring command reference (423 pages)

Table Of Contents

Table of Contents

Parameters

slot slot-number: Specifies an MPU. (In standalone mode.)

chassis chassis-number slot slot-number: Specifies an MPU on an IRF member device. (In IRF

mode.)

cpu cpu-number: Specifies a CPU by its number. If you do not specify this option, the command

specifies a disk space percentage for CPU 0.

ratio limit-ratio: Specifies the ratio of the disk space an MDC can use on the specified card to the

total disk space of the card. The value range is 1 to 100.

Usage guidelines

Before you specify a disk space percentage for an MDC, use the display mdc resource command

to view how much disk space the MDC is using. Make sure the disk space you assign to an MDC is

greater than the disk space the MDC is using. Otherwise, the MDC cannot apply for more disk space

and no additional folders or files can be created or saved for the MDC.

Examples

# (In standalone mode.) Allow MDC sub1 to use up to 30 percent of the disk space on the MPU in

slot 1.

<Sysname> system-view

[Sysname] mdc sub1

[Sysname-mdc-2-sub1] limit-resource disk slot 1 ratio 30

# (In IRF mode.) Allow MDC sub1 to use up to 30 percent of the disk space on the MPU in slot 1 on

IRF member device 2.

<Sysname> system-view

[Sysname] mdc sub1

[Sysname-mdc-2-sub1] limit-resource disk chassis 2 slot 1 ratio 30